Control Switch

Disconnect 2-pin connector at each power seat motor. Using ohmmeter, check continuity between terminal "A" or "B" of control switch connector and specified terminal of motor pigtail connector with control switch in specified position. See CONTROL SWITCH CONTINUITY TEST . SeeFig 1 -Fig 4 . If continuity is not as specified, replace power seat control switch.

CONTROL SWITCH CONTINUITY TEST

Control Switch Position		Continuity Between Terminals
Front Lift
Down		A & F; B & E
Up		A & E; B & F
Rear Lift
Down		A & H; B & G
Up		A & G; B & H
Slide
Forward		A & D; B & C
Rearward		A & C; B & D

Fig 1: Control Switch & Motor Pigtail Connector Terminals Control Switch Id

Courtesy of MAZDA MOTORS CORP.

Fig 2: Control Switch & Motor Pigtail Connector Terminals Slide Motor Id

Courtesy of MAZDA MOTORS CORP.

Fig 3: Control Switch & Motor Pigtail Connector Terminals Front Lift Motor Id

Courtesy of MAZDA MOTORS CORP.

Fig 4: Control Switch & Motor Pigtail Connector Terminals Rear Lift Motor Id

Courtesy of MAZDA MOTORS CORP.