LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1997 >> MX-6 Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Controls - Remove/Install/Overhaul - 2.5L) >> Ignition System >> Crankshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.

Disconnect negative battery cable. Sensor is located on front of engine, near crankshaft pulley. Remove engine undercover. Remove sensor bolts and sensor. Disconnect wiring connector. To install, replace sensor and loosely install mounting bolts. Using a feeler gauge, adjust sensor air gap to .020-.060" (.5-1.5 mm). To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS  .

scientia non olet · About LEMON Manuals