No-Load Test
Connect fully-charged 12-volt battery, voltmeter and ammeter to starter. See Figure . Using remote starter wires or jumper, engage solenoid. Starter should spin smoothly. Compare readings with specifications. See NO-LOAD TEST SPECIFICATIONS table. If voltage is less than specified, amperage is more than specified or shaft speed is less than specified, disassemble and inspect starter components.
NO-LOAD TEST SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Voltage (Minimum) | 11 | ||
| Amperage (Maximum) | 90 | ||
| Shaft Speed (Minimum RPM) | (1) 2800 | ||
|
|||