LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1997 >> B2300 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Engine Controls - Remove/Install/Overhaul) >> Ignition System >> CMP Synchronizer >> Removal (4.0L)

Removal (4.0L)

WARNING: This page is about a different car, the 1997 Mazda B4000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position crankshaft to TDC of cylinder No. 1, on compression stroke. Note position of electrical connector on CMP sensor.
  2. Disconnect negative battery cable. Unplug harness connector from CMP sensor. Remove CMP sensor screws and CMP sensor from positioner. See Figure . Remove synchronizer hold-down bolt and CMP synchronizer.
CAUTION: DO NOT  rotate crankshaft while synchronizer is removed from engine.
scientia non olet · About LEMON Manuals