LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1997 >> 626 DX, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (2.5L V6) >> Overhaul >> Cylinder Block Assembly >> Cylinder Block

Cylinder Block

WARNING: This page is about a different variant/trim than selected.
  1. Inspect cylinder block deck surface warpage. Replace cylinder block if deck warpage exceeds specification. See CYLINDER BLOCK  under ENGINE SPECIFICATIONS.
  2. Measure cylinder bore diameter just below top of bore, at middle of cylinder bore and just above bottom of cylinder bore. Ensure cylinder bore diameter, taper and out-of-round are within specification. If cylinder bore diameter, taper or out-of-round exceeds specification, bore cylinder to nearest oversize. Cylinder block can be bored for .010" (.25 mm) or .020" (.50 mm) oversize pistons.
scientia non olet · About LEMON Manuals