Front Wheel Speed Sensor Rotors: Removal

Drain transaxle fluid. Raise and support vehicle. Remove front wheel assemblies. Remove splash shield. Remove grease cap grease cap and wheel bearing lock nut. Remove upper lateral link ball joint cotter pin and nut. Separate upper lateral link ball stud from steering knuckle using Puller (49-T028-303 and 49-T028-304).

2) Using Puller (49-T028-3A0), separate tie rod end from steering knuckle. Remove lower ball joint-to-lower control arm bolts. Remove drive axle. Using chisel and hammer, remove sensor rotor from drive axle.