Section 627 (Security System And Locks System)
WARNING: This page is about a different car, the 2005 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
- Security And Locks Location Index
- Front Outer Handle Removal/Installation
- Rear Door Release Handle Removal/Installation
- Front Inner Handle Removal/Installation
- Front Door Key Cylinder Removal/Installation
- Front Door Latch And Lock Actuator Removal/Installation
- Front Door Lock Actuator Inspection
- Rear Door Upper Latch Removal/Installation
- Rear Door Upper Latch Switch Inspection
- Rear Door Lower Latch Removal/Installation
- Front Door Lock Striker Removal/Installation
- Rear Door Lock Striker Removal/Installation
- Door Lock Switch Removal/Installation
- Door Lock Switch Inspection
- Fuel-Filler Lid Opener Removal/Installation
- Hood Latch And Release Lever Removal/Installation
- Hood Striker Removal/Installation
- Hood Latch Switch Inspection
- Keyless Control Module Removal/Installation
- Keyless Control Module Inspection
- Keyless Control Module Configuration
- Transmitter Id Code Change
- Transmitter Battery Replacement
- Trunk Lid Latch And Opener Removal/Installation
- Trunk Lid Opener Inspection
- Trunk Key Cylinder Removal/Installation
- Trunk Key Cylinder Switch Inspection
- Trunk Lid Opener Switch Removal/Installation
- Trunk Lid Opener Switch Inspection
- Trunk Lid Striker Removal/Installation
- Trunk Lid Opener Cancel Switch Removal/Installation
- Trunk Lid Opener Cancel Switch Inspection
- Coil Removal/Installation
- Immobilizer System Component Replacement/Key Addition And Clearing
- Foreword
- No.1 Additional Key Registration Procedure (Using Two Valid Keys)
- No.2 Additional Key Registration Procedure (Using the WDS or equivalent)
- No.3 Key Replacement Procedure (Clearing Previously Registered Key ID Numbers, Key Re-registration) Conditions
- No.4 Changing the Method for Registering Additional Keys
- No.5 Resetting Procedure for the Immobilizer System when Replacing the PCM or Keyless Control Module Conditions
- No.6 Security Access Procedure