LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1995 >> MX-6 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 10 (Engine Controls - Remove/Install/Overhaul - 2.5L) >> Ignition System >> Crankshaft Position Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different variant/trim than selected.

Crankshaft position sensor is located on front of engine near crank pulley. To remove, disconnect negative battery cable. Remove idler pulley bracket. Remove dipstick pipe. Disconnect sensor connector. Remove sensor. To install, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS  .

scientia non olet · About LEMON Manuals