No-Load Test
Connect fully-charged 12-volt battery, voltmeter and ammeter to starter. See Figure . Using remote starter wires or jumper, engage solenoid. Starter should spin smoothly. Compare readings with specifications. See NO-LOAD TEST SPECIFICATIONS TABLE . If voltage is less than specified, amperage is more than specified or shaft speed is less than specified, disassemble and inspect starter components.
NO-LOAD TEST SPECIFICATIONS
| Application | Specification | |||
|---|---|---|---|---|
| MX-6 & 626 | ||||
| 4-Cylinder | ||||
| Voltage (Minimum) | 11.0 | |||
| Amperage (Maximum) | 90 | |||
| Shaft Speed (Minimum RPM) | 3000 | |||
| V6 | ||||
| A/T | ||||
| Voltage (Minimum) | 11.0 | |||
| Amperage (Maximum) | 70 | |||
| Shaft Speed (Minimum RPM) | 2200 | |||
| M/T | ||||
| Voltage (Minimum) | 11.0 | |||
| Amperage (Maximum) | 90 | |||
| Shaft Speed (Minimum RPM) | 2900 | |||