Abs Warning Light Flashes With Vehicle Stopped

1. Ensure battery is fully charged. Charge or replace as necessary. If battery is fully charged, go to next step.
2. Check if a jumper wire is installed between terminals TBS and GND of Data Link Connector (DLC). See Fig 1. If jumper wire is installed, remove jumper wire from DLC. If jumper wire is not installed, go to next step.
3. Turn ignition off. Disconnect ABS Control Module (ABS CM) connector. See COMPONENT LOCATIONS . Check continuity between terminal "P" of ABS CM harness connector and ground. See Figure. If continuity exists, repair short to ground in DLC wiring harness. If continuity does not exist, replace ABS CM.

Fig 1: Identifying Data Link Connector (DLC) Terminals

Courtesy of MAZDA MOTORS CORP.