LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1995 >> MX-3 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 95 (Engine Controls - Adjustments) >> Ignition Timing >> 2.0L A/T

2.0L A/T

WARNING: This page is about a different car, the 1996 Mazda MX-6 and 1996 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect New Generation Star (NGS) Tool (49 T088 0A0) to data link connector 2 located under left side of dash. See Fig 1 . Using NSG tool, select PID/DATA MONITOR AND RECORD and monitor RPM.
  2. Connect timing light to engine. Set timing to specification. See IGNITION TIMING SPECIFICATIONS  table. See Fig 3 . If ignition timing is not within specification, check distributor installation. Distributor can not be rotated to adjust ignition timing. Disconnect NGS tool from data link connector 2.
Fig 1: Locating Data Link Connector 2
G95G32280Courtesy of MAZDA MOTORS CORP.
Fig 2: Grounding Terminal No. 10 Of Data Link Connector 1
G00181148Courtesy of MAZDA MOTORS CORP.
Fig 3: Locating Ignition Timing Marks (Typical)
G95G31464Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals