Control Valve Housing: Reassembly
- If tube seats were removed, coat with petroleum jelly and install with Tube Seat Installer (T74P-3504-M
). Coat bearing and seal surface of housing with petroleum jelly. Press bearing into housing using Installer (T65P-3524-A1
) with metal covering rollers facing out. Bearing should rotate freely after installation.
- Coat NEW oil seal with power steering fluid. Drive seal, metal side out, into housing using Installer (T65P-3524-A1
). DO NOT fully seat seal. Remove installer. Place snap ring on seal and finish driving seal in until snap ring seats in groove.
- Place dust seal in housing with dished rubber side facing out. Using Installer (T65P-3524-A1
), press until seal is located behind undercut in input shaft. Apply generous amount of multipurpose grease to area between seal lips.
Courtesy of MAZDA MOTORS CORP.