LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> Navajo DX, RWD >> Repair and Diagnosis >> Transmission >> Clutches >> Hydraulic System Bleeding

Hydraulic System Bleeding

  1. Disconnect hydraulic line at transmission with Disconnector (T88T-70522-A ). See Figure . Clean reservoir cap area. Fill reservoir with DOT 3 brake fluid. Maintain fluid level in reservoir during bleeding procedure.
  2. Using small screwdriver, press and hold internal mechanism of male coupler to open valve. While holding valve open, have assistant slowly press and hold clutch pedal to floor.
  3. Remove screwdriver to allow valve to close. Release clutch pedal. Refill reservoir.
  4. Repeat steps 2) and 3). Install reservoir cap. Reconnect hydraulic line. Tug hydraulic line lightly to verify secure connection.
  5. As rapidly as possible, operate clutch pedal for full 5-10 strokes. Wait 3 minutes. Repeat this step at least times.
  6. Loosen bleed screw, located next to release cylinder connection. Have assistant press and hold clutch pedal. Tighten bleed screw. Release pedal. Refill reservoir. Check clutch operation.
scientia non olet · About LEMON Manuals