Control Switch
Disconnect control switch 6-pin connector. Disconnect 2-pin connector at each seat motor. Check continuity between specified terminal of control switch connector and specified terminal of motor connector with control switch in specified position. See CONTROL SWITCH CONTINUITY TEST table. SeeFig 1 . If continuity does not exist between terminals as specified, replace control switch.
CONTROL SWITCH CONTINUITY TEST
| Switch Position | Terminals | |
|---|---|---|
| Front Lift Switch | ||
| Down | "A" & "F"; "B" & "E" | |
| Up | "A" & "E"; "B" & "F" | |
| Rear Lift Switch | ||
| Down | "A" & "H"; "B" & "G" | |
| Up | "A" & "G"; "B" & "H" | |
| Slide Switch | ||
| Backward | "A" & "D"; "B" & "C" | |
| Forward | "A" & "C"; "B" & "D" | |