LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> B4000 LE, RWD, Standard >> Repair and Diagnosis >> Steering >> Steering Column >> Adjustments >> Ignition Switch

Ignition Switch

  1. Ignition switch is properly adjusted if:
    • In ACCESSORY position, accessory circuit is operative and steering wheel is locked. Automatic shift lever cannot be moved.
    • In LOCK position, all ignition switch electrical circuits are inoperative and steering wheel is locked. Automatic shift lever cannot be moved.
    • In OFF position, all ignition switch electrical circuits are inoperative and steering wheel is unlocked. Automatic shift lever can be moved.
    • In ON (RUN) position, all ignition switch circuits or accessory circuits are operative except starter circuit and warning light check circuit. Steering wheel is unlocked and automatic shift lever can be moved.
    • In START position, only engine ignition, warning light check and starter circuits are operative. Steering wheel is unlocked and automatic shift lever can be moved.
  2. To adjust ignition switch, disconnect negative battery cable. Locate ignition switch on top of steering column tube. Disconnect ignition switch connector. Rotate ignition key back and forth to each side of LOCK position until a .078" (1.98 mm) drill bit can be inserted into ignition switch lock pin hole.
  3. Loosen 2 ignition switch mounting nuts, turn key to LOCK position (feel for detent) and remove ignition key from cylinder. Move switch up or down along column tube. Locate mid-position of rod lash. Tighten mounting nuts to specification. See TORQUE SPECIFICATIONS .
  4. Remove drill bit. Reconnect ignition switch electrical connector. Verify all accessories are deactivated when switch is in OFF position. Ensure all switch positions function properly.
scientia non olet · About LEMON Manuals