LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> B3000 Base, 2D Pickup, Standard >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Crankshaft Position Sensor >> Removal (B2300)

Removal (B2300)

  1. Disconnect negative battery cable. Disconnect crankshaft position sensor wiring harness connector. Mark wires for reassembly purpose. See Figure . Pry out Red retaining clip and remove wires from harness terminal.
    NOTE: Always turn engine in direction of normal rotation (clockwise as viewed from front of engine).
  2. Remove serpentine drive belt. Remove crankshaft pulley. Remove outer timing belt cover. Rotate keyway on crankshaft to 10 o'clock position. Ensure vane window of inner and outer vane cups are placed over crankshaft position sensor. Remove crankshaft hub.
  3. Remove crankshaft position sensor mounting screws. Slide wires out past inner timing belt cover, and remove sensor with wire harness retainer.
scientia non olet · About LEMON Manuals