LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1994 >> B3000 Base, 2D Pickup, Automatic >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System - Power >> Testing >> Valve Spool Centering

Valve Spool Centering

NOTE: Only control valve housing and 4 valve sleeve "O" rings are serviceable.
  1. Install a 0-2000 psi pressure gauge and valve assembly between power steering pump and high pressure line. Ensure gauge valve is completely OPEN. Remove horn button from steering wheel. Attach an INCH-lb. torque wrench to steering wheel nut. Center steering wheel. Set engine idle to 1000 RPM. Using torque wrench, rotate steering shaft to either side of center to obtain reading of 250 psi (17.5 kg/cm2 ) in each direction.
    NOTE: Ensure power steering fluid is at normal operating temperature and at correct level.
  2. Torque reading should be equal in both directions at 250 psi (17.5 kg/cm2 ). If difference between readings exceeds 6 INCH lbs. (.68 N.m), remove steering gear. Replace shaft and control assembly.
scientia non olet · About LEMON Manuals