Function Test
On all models except 2.0L A/T, start engine to supply vacuum to actuator diaphragm. On all models, observe actuator arm when battery voltage is applied across specified terminals of actuator connector. See ACTUATOR FUNCTION TEST table. See Figure and Figure . If actuator arm does not function as specified, replace actuator.
ACTUATOR FUNCTION TEST
| Application | Actuator Arm Result | |
|---|---|---|
| 2.0L A/T | ||
| Apply 12 Volts To Terminal "A" & Ground Terminals "B", "C" & "D" | Pull | |
| Apply 12 Volts To Terminal "A" & Ground Terminals "B" & "C" | Hold | |
| Apply 12 Volts To Terminal "A" & Ground Terminal "B" | Extend | |
| Disconnect All Voltage & Ground | Release | |
| 2.0L M/T & 2.5L | ||
| Apply 12 Volts To Terminal "B" & Ground Terminals "A", "C" & "D" | Pull | |
| Apply 12 Volts To Terminal "B" & Ground Terminals "A" & "D" | Hold | |
| Apply 12 Volts To Terminal "B" & Ground Terminal "D" | Extend | |
| Disconnect All Voltage & Ground | Release | |