Both Retractors Inoperative Using Either Switch
- Check HEAD and RETRA fuses in main fuse block. If fuse is faulty, replace fuse (repair circuit if shorted). If fuse is okay, remove retractor switch. Measure voltage at terminal "C" of retractor switch connector. SeeFig 1
. If battery voltage is not present, repair Red wire.
- If battery voltage is present, disconnect retractor switch connector. Turn on retractor switch. Check continuity between terminals "A" and "C" of retractor switch connector. Turn off switch. Check continuity between terminals "B" and "C". Continuity should exist in both checks.
- If continuity is not as specified, replace retractor switch. If continuity is as specified, reconnect retractor switch connector. Disconnect retractor motor connector. Measure voltage at Black/White wire terminal of retractor motor connector. If battery voltage is not present, repair wire between RETRA fuse and retractor motor.
- If battery voltage is present, check continuity between ground and Black wire terminal of retractor motor connector. If continuity is not present, repair wire between retractor motor and ground. If battery voltage is present, check retractor motor. See RETRACTOR MOTOR TEST. If retractor motor is okay, check for mechanical problem.
Courtesy of MAZDA MOTORS CORP.