Power Seats (One Function Inoperative)
- With control switch held in specified position, measure voltage at specified wire terminal of seat motor assembly connector. See VOLTAGE TEST table. If battery voltage is present at both terminals for seat motor being tested, replace seat motor.
- If battery voltage is not present, check continuity of wiring between control switch and seat motor. If there is no continuity, repair wiring. If there is continuity, replace control switch.
VOLTAGE TEST
| Switch Position | Wire Terminal | |
|---|---|---|
| Forward/Backward | ||
| Forward | Yellow/Light Green | |
| Backward | Orange/Light Blue | |
| Front Height | ||
| Up | Light Green/Orange | |
| Down | Orange/Yellow | |
| Rear Height | ||
| Up | Light Green/Yellow | |
| Down | White/Light Blue | |