Window Regulator: Installation
- Glass bracket assembly and regulator assembly must be installed in vehicle as one assembly. Glass bracket assembly may be disassembled from regulator as described in steps 4 and 5 of removal procedure. To install regulator with pre-assembled glass bracket into vehicle, set regulator base plate to door inner panel using base plate locator tab as a guide.
- Install four rivets to attach regulator to door inner panel. As an alternate method of glass retention, two 1/4-20 x 1" bolts and two 1/4-20 nuts and washer assemblies may be used. Torque must NOT exceed 3-5 ft. lbs. (4-7 N.m). Equivalent metric retainers may be used.
- Install equalizer bracket. Install inside door belt weather strip and glass stabilizer. Lower regulator arms to access holes in door inner panel. Install door glass. See DOOR WINDOW .
- Adjust glass to ensure proper alignment with glass run. Cycle glass for smooth operation. Install door trim panel and water shield. See DOOR TRIM PANEL & WATER SHIELD .