Window Mechanism
- Remove door trim panel and water shield. See DOOR TRIM PANEL & WATER SHIELD under REMOVAL & INSTALLATION. Lower glass about 3" (75 mm) from full UP position.
- Loosen nut and washer assemblies retaining equalizer bracket to door inner panel. See Figure . Open door and place hands on each side of glass. Carefully pull glass fully into door glass run assembly at "B" pillar.
- Tighten nut and washer. Apply downward pressure on equalizer bracket and tighten nut and washer to 7-10 ft. lbs. (9-14 N.m). Cycle door glass to ensure proper functioning and door fit. Install water shield and trim panel. See DOOR TRIM PANEL & WATER SHIELD under REMOVAL & INSTALLATION.