Clutch Assembly: Inspection
- Check disc for loose rivets, worn springs or oil contamination. Minimum lining height above the rivet heads is .012" (.30 mm). Inspect the flywheel and pressure plate for burns, scoring or grooves.
- Check flywheel and pressure plate runout. Resurface or replace flywheel and pressure plate if beyond specification. See the CLUTCH COMPONENT RUNOUT (MAXIMUM) . If flywheel ring gear is replaced, ensure chamfer on flywheel teeth faces engine.
- Check clutch disc runout using dial indicator. Replace if out of specification. See CLUTCH COMPONENT RUNOUT (MAXIMUM) . Check disc hub and input shaft splines for excessive wear. Hub must slide smoothly on input shaft splines.
CLUTCH COMPONENT RUNOUT (MAXIMUM)
| Application | In. (mm) | |
|---|---|---|
| Disc | ||
| B2200, RX7 & 929 | 0.028 (0.7) | |
| B2600i & MPV | 0.040 (1.0) | |
| Flywheel (All Models) | 0.008 (.20) | |