LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1986 >> 626 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Controls - Remove/Install/Overhaul) >> Ignition System >> CMP Synchronizer >> Removal (B3000 & B4000)

Removal (B3000 & B4000)

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1998 Mazda Protege, 1998 Mazda Millenia, 1998 Mazda MPV, 1998 Mazda B4000, and 1998 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position crankshaft to TDC of cylinder No. 1, on compression stroke. Note position of electrical connector on CMP sensor.
  2. Disconnect negative battery cable. Unplug harness connector from CMP sensor. Remove CMP sensor screws and CMP sensor from positioner. See Figure. Remove synchronizer hold-down bolt and CMP synchronizer.
CAUTION: Do not rotate crankshaft while synchronizer is removed from engine.
scientia non olet · About LEMON Manuals