Removal & Installation
NOTE:
Negative cable should be disconnected at battery when working on fuel pump.
- On 626 and RX7 models, open trunk lid, lift mat and disconnect fuel pump electrical lead. Raise rear of vehicle and support on stands. Remove fuel pump cover attaching bolts and cover.
- On all models, disconnect inlet and outlet hoses and wiring connector. Remove attaching bolts and nuts and take pump off vehicle. To install, reverse removal procedure.
SPECIFICATIONS
| Application | Pressure psi (kg/cm2 ) | Volume oz./minute |
|---|---|---|
| Courier | 2.8-3.6 (.20-.25) | 32 |
| 626 | 2.8-3.6 (.20-.25) | 26 |
| RX7 | 3.7-4.7 (.26-.33) | 37 |
| B2000 | 2.8-3.6 (.20-.25) | 26 |