Hydraulic System Bleeding
- System must be bled whenever a line as been disconnected. To bleed system, remove rubber cap from bleeder plug and attach a rubber hose.
- Insert other end of hose in a container half full of fluid. Open bleeder plug and depress clutch pedal. Allow pedal to return slowly.
- Continue pumping action on pedal until air bubbles are not longer seen in container. Close bleeder plug and make sure fluid in reservoir is to full mark. Remove hose and install cap on bleeder plug.
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. (mkg) |
|---|---|
| Clutch-to-Flywheel | 20 (2.8) |
| Master Cylinder Retaining Bolts | 20(2.8) |