Pinpoint Test V : VDM (Vehicle Dynamics Control Module) Configuration Concern
WARNING: This page is about a different car, the 2020 Lincoln Aviator. However, it is still accessible from the selected car via links, so may be relevant.
- Normal Operation and Fault Conditions
REFER to: Vehicle Dynamic Suspension - System Operation and Component Description .
DTC Fault Trigger Conditions
DTC Description Fault Trigger Condition VDM U2024: 51 Control Module Cal-Config Data: Not Programmed Sets as a continuous memory DTC due to incomplete or improper VDM programming. VDM U2100: 00 Initial Configuration Not Complete: No Sub Type Information Sets as a continuous memory DTC due to incomplete or improper VDM programming. VDM U2200: 00 Control Module Configuration Memory Corrupt: No Sub Type Information Sets as a continuous memory DTC due to incomplete or improper VDM programming. VDM U3000: 04 Control Module: System Internal Failures Sets as a continuous memory DTC due to incomplete or improper VDM programming. VDM U3000: 49 Control Module: Internal Electronic Failure Sets as a continuous memory DTC when the VDM has disabled an output due to an overload condition. VDM U1000: 00 Solid State Driver Protection Active -Driver Disabled: No Sub Type Information Sets as a continuous memory DTC when the VDM has disabled an output due to an overload condition. Possible Sources
- VDM configuration
- VDM
- V1 CHECK FOR OTHER VDM (VEHICLE DYNAMICS CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, check the VDM Diagnostic Trouble Codes (DTCs).
Are any Diagnostic Trouble Codes (DTCs) other than U2024: 51, U2100: 00, U2200: 00, U3000: 04, U3000: 49, or U1000: 00 present in the VDM?
Yes DIAGNOSE all other VDM Diagnostic Trouble Codes (DTCs) before continuing this test. REFER to the VDM DTC Chart in this information. No GO to V2 - V2 CHECK THE VEHICLE SERVICE HISTORY
- Check the vehicle service history for recent service actions related to the VDM.
Are any recent service actions related to the VDM found?
Yes INSTALL As-Built data for the VDM following the diagnostic scan tool instructions. REFER to: Vehicle Dynamics Control Module (VDM) . No GO to V3 - V3 RECHECK THE VDM (VEHICLE DYNAMICS CONTROL MODULE) DIAGNOSTIC TROUBLE CODES (DTCS)
- Ignition ON.
- Using a diagnostic scan tool, clear the VDM Diagnostic Trouble Codes (DTCs).
- Using a diagnostic scan tool, carry out the VDM self-test.
Is DTC U2024: 51, U2100: 00, U2200: 00, U3000: 04, U3000: 49, or U1000: 00 still present?
Yes INSTALL a new VDM. REFER to: Vehicle Dynamics Control Module (VDM) . No The system is operating correctly at this time. The concern may have been caused by an intermittent condition.