Pinpoint Test V: The Power Liftgate Passive Entry Feature Is Inoperative
- V1 CHECK THE RKE (REMOTE KEYLESS ENTRY) OPERATION
- Ignition OFF.
- Close the liftgate.
- Press the liftgate release button twice on a valid programmed passive key.
Does the liftgate power open?
Yes GO to V2 No GO to Pinpoint Test Q - V2 CHECK THE LIFTGATE RELEASE SWITCH INPUT
- Close the liftgate.
- Ignition ON.
- Unlock the doors using the door lock control switch.
- Press the liftgate release button located at the rear of the vehicle.
Does the liftgate power open?
Yes GO to V3 No REFER to: Body Closures . - V3 CHECK THE KEYLESS ENTRY REAR ANTENNA
- Ignition OFF.
- Disconnect: Keyless Entry Rear Antenna C4332.
- Measure:
Positive Lead Measurement / Action Negative Lead
C4332, pin 1, component side
C4332, pin 2, component side
Is the resistance between 1 and 3 ohms?
Yes GO to V4 No INSTALL a new keyless entry rear antenna. REFER to: Keyless Entry Rear Antenna . - V4 CHECK THE KEYLESS ENTRY REAR ANTENNA CIRCUITS FOR A SHORT TO VOLTAGE
- Disconnect: BCM C2280D.
- Ignition ON.
Is any voltage present?
Yes REPAIR the circuit in question. No GO to V5 - V5 CHECK THE KEYLESS ENTRY REAR ANTENNA CIRCUITS FOR A SHORT TO GROUND
- Ignition OFF.
Are the resistances greater than 10, 000 ohms?
Yes GO to V6 No REPAIR the circuit in question. - V6 CHECK THE KEYLESS ENTRY REAR ANTENNA CIRCUITS FOR AN OPEN
Are the resistances less than 3 ohms?
Yes GO to V7 No REPAIR the circuit in question. - V7 CHECK FOR CORRECT BCM (BODY CONTROL MODULE) OPERATION
- Disconnect and inspect all the BCM connectors.
- Repair:
- corrosion (install new connectors or terminals - clean module pins)
- damaged or bent pins - install new terminals pins
- pushed-out pins - install new pins as necessary
- Reconnect the BCM connectors and make sure they seat and latch correctly.
- Operate the system and determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM, or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern, Refer to . No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.