Steering Column Switches DTCS: SCCM
| DTC | Description | Action |
|---|---|---|
| B1008:09 | Wiper Mode Switch: Component Failure | REFER to: Wipers and Washers . |
| B1051:09 | Front Washer Switch: Component Failure | REFER to: Wipers and Washers . |
| B1052:09 | Rear Washer Switch: Component Failure | REFER to: Wipers and Washers . |
| B10AD:02 | Rain Sensor: General Signal Failure | REFER to: Wipers and Washers . |
| B10AD:08 | Rain Sensor: Bus Signal/Message Failure | REFER to: Wipers and Washers . |
| B10AD:49 | Rain Sensor: Internal Electronic Failure | REFER to: Wipers and Washers . |
| B10AD:55 | Rain Sensor: Not Configured | REFER to: Wipers and Washers . |
| B1131:02 | Wiper motor module: General Signal Failure | REFER to: Wipers and Washers . |
| B1131:08 | Wiper motor module: Bus Signal/Message Failure | REFER to: Wipers and Washers . |
| B1131:11 | Wiper motor module: Circuit Short To Ground | REFER to: Wipers and Washers . |
| B1131:49 | Wiper motor module: Internal Electronic Failure | REFER to: Wipers and Washers . |
| B1131:55 | Wiper motor module: Not Configured | REFER to: Wipers and Washers . |
| B1131:9A | Wiper motor module: Component or System Operating Conditions | REFER to: Wipers and Washers . |
| B11D9:16 | Vehicle Battery: Circuit Voltage Below Threshold | GO to Pinpoint Test I |
| B11D9:17 | Vehicle Battery: Circuit Voltage Above Threshold | GO to Pinpoint Test J |
| B1298:09 | Steering Column Adjust Up Switch: Component Failure | REFER to: STEERING COLUMN . |
| B1299:09 | Steering Column Adjust Down Switch: Component Failure | REFER to: STEERING COLUMN . |
| B124C:00 | Turn Indicator Stalk Switch Pack: No Sub Type Information | REFER to: HEADLAMPS . |
| B124C:96 | Turn Indicator Stalk Switch Pack: Component Internal Failure | REFER to: HEADLAMPS Headlamps . |
| B12A1:09 | Steering Column Adjust Out Switch: Component Failure | REFER to: STEERING COLUMN . |
| B12F7:09 | Single Wipe Switch: Component Failure | REFER to: Wipers and Washers . |
| B12A1:09 | Steering Column Adjust Out Switch: Component Failure | REFER to: STEERING COLUMN . |
| B12A2:09 | Steering Column Adjust In Switch: Component Failure | REFER to: STEERING COLUMN . |
| B137F:09 | Steering Wheel Left Switch Pack: Component Failure | REFER to: CRUISE CONTROL . |
| B137F:11 | Steering Wheel Left Switch Pack: Circuit Short to Ground | REFER to: CRUISE CONTROL . |
| B137F:17 | Steering Wheel Left Switch Pack: Circuit Voltage Above Threshold | REFER to: CRUISE CONTROL . |
| B1380:09 | Steering Wheel Right Switch Pack: Component Failure | Refer to the appropriate Information and Entertainment Systems article for the procedure. |
| B1380:11 | Steering Wheel Right Switch Pack: Circuit Short to Ground | Refer to the appropriate Information and Entertainment Systems article for the procedure. |
| B1380:17 | Steering Wheel Right Switch Pack: Circuit Voltage Above Threshold | Refer to the appropriate Information and Entertainment Systems article for the procedure. |
| B13A6:09 | Lane Departure Warning Switch Input: Component Failure | REFER to: Lane Keeping System . |
| B1D36:09 | Turn Indicator Switch: Component Failure | REFER to: TURN SIGNAL AND HAZARD LAMPS . |
| U0121:00 | Lost Communication with Anti-Lock Brake System (ABS) Control Module: No Sub-Type Information | GO to Pinpoint Test R |
| U0140:08 | Lost Communication With Body Control Module: Bus Signal / Message Failure | GO to Pinpoint Test S |
| U023A:08 | Lost Communication With Image Processing Module A: Bus Signal / Message Failure | GO to Pinpoint Test T |
| U0241:08 | Lost Communication With Headlamp Control Module A: Bus Signal / Message Failure |
NOTE:
This DTC only sets on Navigator vehicles. GO to Pinpoint Test U |
| U0415:00 | Invalid Data Received From ABS: No Sub Type Information |
NOTE:
This DTC sets in a module that is reporting a missing or invalid message from another module on the data bus. The module that reports the fault is not the problem module. Do not install a new SCCM as part of the repair unless directed to do so in a pinpoint test. CHECK for additional SCCM and ABS Diagnostic Trouble Codes (DTCs). DIAGNOSE and REPAIR any Diagnostic Trouble Codes (DTCs) that are retrieved. For SCCM Diagnostic Trouble Codes (DTCs), REFER to SCCM DTC Chart
. For ABS Diagnostic Trouble Codes (DTCs), REFER to: Anti-Lock Brake System (ABS) and Stability Control
. |
| U0422:08 | Invalid Data Received From Body Control Module: Bus Signal / Message Failure |
NOTE:
This DTC sets in a module that is reporting a missing or invalid message from another module on the data bus. The module that reports the fault is not the problem module. Do not install a new SCCM as part of the repair unless directed to do so in a pinpoint test. CHECK for additional SCCM and BCM Diagnostic Trouble Codes (DTCs). DIAGNOSE and REPAIR any Diagnostic Trouble Codes (DTCs) that are retrieved. For SCCM Diagnostic Trouble Codes (DTCs), REFER to SCCM DTC Chart
. For BCM Diagnostic Trouble Codes (DTCs), REFER to: BODY CONTROL MODULE (BCM)
. |
| U053B:08 | Invalid Data Received From Image Processing Module A:Bus Signal / Message Failure |
NOTE:
This DTC sets in a module that is reporting a missing or invalid message from another module on the data bus. The module that reports the fault is not the problem module. Do not install a new SCCM as part of the repair unless directed to do so in a pinpoint test. CHECK for additional SCCM and IPMA Diagnostic Trouble Codes (DTCs). DIAGNOSE and REPAIR any Diagnostic Trouble Codes (DTCs) that are retrieved. For SCCM Diagnostic Trouble Codes (DTCs), REFER to the SCCM DTC Chart. For IPMA Diagnostic Trouble Codes (DTCs), REFER to:LANE KEEPING SYSTEM
. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | Check vehicle service history for recent service actions related to this module. This DTC will set due to incomplete or improper PMI procedures. If there have been recent service actions with this module, REPEAT/CARRY OUT the PMI procedure as directed by the diagnostic scan tool. If there have been no recent service actions, INSTALL a new module to correct the failure to retain configuration data. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets if the steering wheel switches do not match the switch function configuration data in the SCCM. CHECK the parts catalog and CONFIRM that the correct SCCM and steering wheel control switches are installed in the vehicle. INSTALL the correct components, as necessary. |
| U3000:49 | Control Module: Internal Electronic Failure | INSTALL a new SCCM. REFER to: Steering Column Control Module (SCCM) . |