| P06E4 |
Control Module Wake-up Circuit Performance |
RETRIEVE and RECORD all CM DTCs. If BCM DTC C113A:11 or C113A:15 is found, GO to Pinpoint Test C
Clear all Diagnostic Trouble Codes (DTCs). RERUN the PCM self-test. If the DTC returns, CHECK OASIS for any applicable Technical Service Bulletins (TSBs). If no Technical Service Bulletins (TSBs) address this concern, INSTALL a new PCM. REFER to: Powertrain Control Module (PCM)
. |
| P06E9 |
Engine Starter Performance |
If the engine cranks, Refer to ENGINE CONTROLS - INTRODUCTION (EXCEPT DIESEL & HYBRID)
. If the engine does not crank, GO to Pinpoint Test A |
| P162F |
Starter Motor Disabled - Engine Crank Time Too Long |
This DTC sets in the PCM when the engine has been cranked for more than a total of 60 seconds without allowing sufficient time for the starter to cool. Diagnose all other DTCs and symptoms. Check the charging system voltage and correct as necessary. Clear the DTC. |
| P2534 |
Ignition Switch Run/Start Position Circuit Low |
GO to Pinpoint Test D |
| P2535 |
Ignition Switch Run/Start Position Circuit High |
GO to Pinpoint Test D |
| All Other DTCs |
- |
REFER to: Electronic Engine Controls
. |