Pinpoint Test H : DTC P0814: Notes
Refer to Wiring Diagram Transmission Controls for schematic and connector information.
Normal Operation and Fault Conditions
The GSM cannot sense the selected gear position or is unable to boot up, upon the ignition being put into the Run position.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0814 | Transmission Range Display Circuit | This CM DTC sets if the GSM is not able to detect selector lever position indicator LED illumination. |
Possible Sources
- Connectors damaged or pushed-out terminals, circuitry open or high resistance in the voltage feed wiring to the GSM or a loose ground.
- Discharged battery/charging system
- GSM
- Selector lever cable misadjusted