Removal And Installation
WARNING: This page is about a different car, the 2018 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Installation of a new receiver/drier desiccant bag is not required when repairing the A/C system, except when there is physical evidence of contamination from a failed A/C compressor or damage to the receiver/drier desiccant bag. Damage to the receiver/drier desiccant bag includes physical damage to the receiver/drier desiccant bag or moisture contamination. Moisture contamination results only from a complete loss of refrigerant and equalization of the refrigerant system pressure with atmospheric pressure for a period longer than one hour. If even a slight amount of positive refrigerant pressure is present in the system before repairs are carried out, the receiver/drier desiccant bag should not be replaced.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Jacking and Lifting .
- Recover the refrigerant. For additional information, refer to Climate Control System General Information .
- Release the 4 underbody shield retainers and remove the underbody shield (if equipped).
- Remove the lower radiator splash shield.
- Remove the integrated receiver/drier plug and remove the receiver/drier cartridge.
- To install, reverse the removal procedure.
- Install new gasket seals and O-ring seals.
- Add the correct amount of clean PAG oil to the refrigerant system. For additional information, refer to the Refrigerant Oil Adding procedure in Climate Control System General Information .
- Evacuate, leak test and charge the refrigerant system. For additional information, refer to Climate Control System General Information .