| B1045:11 |
Chime: Circuit Short To Ground |
GO to Pinpoint Test F |
| B1045:12 |
Chime: Circuit Short To Battery |
GO to Pinpoint Test F |
| B1045:13 |
Chime: Circuit Open |
GO to Pinpoint Test F |
| B1306:11 |
Liftgate Ajar Switch: Circuit Short To Ground |
DIAGNOSE the incorrect luggage compartment lid ajar message. REFER to: Instrumentation, Message Center and Warning Chimes
. |
| B1306:12 |
Liftgate Ajar Switch: Circuit Short To Battery |
DIAGNOSE the incorrect luggage compartment lid ajar message. REFER to: Instrumentation, Message Center and Warning Chimes
. |
| B144D:29 |
Tailgate/Liftgate/Boot/Trunk Position Sensor 1: Signal Invalid |
GO to Pinpoint Test B |
| B144E:29 |
Tailgate/Liftgate/Boot/Trunk Position Sensor 2: Signal Invalid |
GO to Pinpoint Test B |
| B144F:11 |
Tailgate/Liftgate/Boot/Trunk Driver Motor: Circuit Short To Ground |
GO to Pinpoint Test B |
| B144F:12 |
Tailgate/Liftgate/Boot/Trunk Driver Motor: Circuit Short To Battery |
GO to Pinpoint Test B |
| B144F:13 |
Tailgate/Liftgate/Boot/Trunk Driver Motor: Circuit Open |
GO to Pinpoint Test B |
| B144F:79 |
Tailgate/Liftgate/Boot/Trunk Driver Motor: Mechanical Linkage Failure |
GO to Pinpoint Test B |
| B1452:11 |
Tailgate/Liftgate/Boot/Trunk Latch Release Actuator: Circuit Short To Ground |
GO to Pinpoint Test A |
| B1452:13 |
Tailgate/Liftgate/Boot/Trunk Latch Release Actuator: Circuit Open |
GO to Pinpoint Test A |
| B1453:29 |
Tailgate/Liftgate/Boot/Trunk Latch Position Switch: Signal Invalid |
GO to Pinpoint Test D |
| B145D:11 |
Tailgate/Liftgate/Boot/Trunk Power Cinch Striker Motor: Circuit Short To Ground |
GO to Pinpoint Test D |
| B145D:12 |
Tailgate/Liftgate/Boot/Trunk Power Cinch Striker Motor: Circuit Short To Battery |
GO to Pinpoint Test D |
| B145D:13 |
Tailgate/Liftgate/Boot/Trunk Power Cinch Striker Motor: Circuit Open |
GO to Pinpoint Test D |
| B1A59:11 |
Sensor 5 Volt Supply: Circuit Short To Ground |
GO to Pinpoint Test B |
| B1A59:13 |
Sensor 5 Volt Supply: Circuit Open |
GO to Pinpoint Test B |
| U0101:87 |
Lost Communication with TCM: Missing Message |
GO to Pinpoint Test G |
| U0140:87 |
Lost Communication With Body Control Module: Missing Message |
GO to Pinpoint Test H |
| U0294:87 |
Lost Communication With Powertrain Control Monitor Module: Missing Message |
GO to Pinpoint Test I |
| U201A:55 |
Control Module Main Calibration Data: Not Configured |
CARRY OUT the Programmable Module Installation (PMI) procedure using As-Built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If DTC U201A:55 returns, INSTALL a new RGTM. REFER to: Rear Gate Trunk Module (RGTM)
. |
| U2300:55 |
Central Configuration: Not Configured |
CARRY OUT the Programmable Module Installation (PMI) procedure using As-Built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If DTC U2300:55 returns, INSTALL a new RGTM. REFER to: Rear Gate Trunk Module (RGTM)
. |
| U2300:56 |
Central Configuration: Invalid / Incompatible Configuration |
CARRY OUT the Programmable Module Installation (PMI) procedure using As-Built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If DTC U2300:56 returns, INSTALL a new RGTM. REFER to: Rear Gate Trunk Module (RGTM)
. |
| U3000:09 |
Control Module: Component Failure |
INSTALL a new RGTM. REFER to: Rear Gate Trunk Module (RGTM)
. |
| U3000:41 |
Control Module: General Checksum Failure |
CARRY OUT the Programmable Module Installation (PMI) procedure using As-Built data. CLEAR the Diagnostic Trouble Codes (DTCs) and REPEAT the self-test. If DTC U3000:41 returns, INSTALL a new RGTM. REFER to: Rear Gate Trunk Module (RGTM)
. |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to Pinpoint Test J |
| U3003:17 |
Battery Voltage: Circuit Voltage Above Threshold |
GO to Pinpoint Test K |