Start/Stop Switch

The start/stop switch is a momentary contact switch that is hardwired to the RFA module, BCM, and the PCM. The start/stop switch is connected to both the RFA module and BCM as a backup in case of a switch or circuit failure. In the event of a switch failure or a circuit failure between the switch and one of the modules, the module that receives the start/stop switch request transmits the request over the MS-CAN to the other module to enable ignition system operation.

The start/stop switch also has 2 LEDs, one is used for switch illumination and the other to indicate ignition mode. The ignition mode LED only illuminates when the vehicle is in RUN or START mode, it does not illuminate in ACC mode.