With THX: TCU
| DTC | Description | Action |
|---|---|---|
| B116C:04 | External SIM Cable/ SIM Card: System Internal Failure | GO to Pinpoint Test AG |
| B1246:11 | GSM (Group System for Mobile) Antenna: Circuit Short To Ground | GO to Pinpoint Test AY |
| B1246:13 | GSM (Group System for Mobile) Antenna: Circuit Open | GO to Pinpoint Test AY |
| B1D55:11 | Antenna #2: Circuit Short To Ground | GO to Pinpoint Test AZ |
| B1D55:13 | Antenna #2: Circuit Open | GO to Pinpoint Test AZ |
| U0100:00 | Lost Communication with ECM/ PCM "A": No Sub Type Information | GO to Pinpoint Test AK |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AM |
| U0155:00 | Lost Communication With Instrument Panel Cluster (IPC) Control Module: No Sub Type Information | GO to Pinpoint Test AO |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test AU |
| U2024:00 | Control Module Cal-Config Data: No Sub Type Information | This DTC sets due to an incorrect or incomplete TCU configuration. Using a diagnostic scan tool, PERFORM the TCU programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration - System Operation and Component Description . See: As-Built Data. |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incorrect or incomplete TCU configuration. Using a diagnostic scan tool, PERFORM the TCU programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration - System Operation and Component Description . See: As-Built Data. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to an incorrect or incomplete TCU configuration. Using a diagnostic scan tool, PERFORM the TCU programming procedure using as-built data. For information on as-built data, REFER to: Module Configuration - System Operation and Component Description . See: As-Built Data. |
| U3000:09 | Control Module: Component Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CM DTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CM DTCs). If DTC U3000:09 is retrieved again, DISCONNECT the battery for 1 minute, then reconnect it. CLEAR all Continuous Memory Diagnostic Trouble Codes (CM DTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CM DTCs). If DTC U3000:09 is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module . |
| U3000:41 | Control Module: General Checksum Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CM DTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CM DTCs). If DTC U3000:41 is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module . |
| U3000:42 | Control Module: General Memory Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CM DTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CM DTCs). If DTC U3000:42 is retrieved again, INSTALL a new TCU. REFER to: Telematics Control Unit (TCU) Module . |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test AW |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test AX |