| U0104:00 |
Lost Communication With Cruise Control Module: No Sub Type Information |
GO to Pinpoint Test C |
| U0146:00 |
Lost Communication With Gateway "A": No Sub Type Information |
GO to Pinpoint Test D |
| U0405:68 |
Invalid Data Received From Cruise Control Module: Event Information |
This DTC sets when the HUD module receives invalid network data from the CCM with a faulted signal data input. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network. |
| U0447:68 |
Invalid Data Received From Gateway "A": Event Information |
This DTC sets when the HUD module receives invalid network data from the GWM. RETRIEVE and REPAIR all non-network Diagnostic Trouble Codes (DTCs) in the other modules on the network |
| U210A:16 |
Temperature Sensor: Circuit Voltage Below Threshold |
GO to Pinpoint Test F |
| U210A:17 |
Temperature Sensor: Circuit Voltage Above Threshold |
GO to Pinpoint Test F |
| U3000:41 |
Control Module: General Checksum Failure |
CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If DTC U3000:41 is retrieved again, INSTALL a new HUD module. REFER to: Head Up Display (HUD) Module
. |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to Pinpoint Test G |
| U3003:1C |
Battery Voltage: Circuit Voltage Out of Range |
GO to Pinpoint Test H |