| B1060:11 |
Seat Headrest Motor Output: Circuit Short To Ground |
REFER to: Rear Seats
. |
| B1060:15 |
Seat Headrest Motor Output: Circuit Short To Battery or Open |
REFER to: Rear Seats
. |
| B106E:23 |
Headrest Down Switch: Signal Stuck Low |
REFER to: Rear Seats
. |
| B1298:23 |
Steering Column Adjust Up Switch |
REFER to: Steering Column
. |
| B1299:23 |
Steering Column Adjust Down Switch: Signal Stuck Low |
REFER to: Steering Column
. |
| B12A1:23 |
Steering Column Adjust Out Switch: Signal Stuck Low |
REFER to: Steering Column
. |
| B12A2:23 |
Steering Column Adjust In Switch: Signal Stuck Low |
REFER to: Steering Column
. |
| B1375:11 |
Steering Column Tilt Motor: Circuit Short To Ground |
REFER to: Steering Column
. |
| B1375:15 |
Steering Column Tilt Motor: Circuit Short To Battery or Open |
REFER to: Steering Column
. |
| B137E:11 |
Steering Column Telescope Motor: Circuit Short To Ground |
REFER to: Steering Column
. |
| B137E:15 |
Steering Column Telescope Motor: Circuit Short To Battery or Open |
REFER to: Steering Column
. |
| B1C33:29 |
Steering Column Tilt Feedback Signal: Signal Invalid |
REFER to: Steering Column
. |
| B1C35:29 |
Steering Column Telescope Feedback Signal: Signal Invalid |
REFER to: Steering Column
. |
| U0140:00 |
Lost Communication With Body Control Module: No Sub Type Information |
GO to Pinpoint Test B |
| U0208:00 |
Lost Communication With "Seat Control Module A": No Sub Type Information |
GO to Pinpoint Test C |
| U0294:00 |
Lost Communication With Powertrain Control Monitor Module: No Sub Type Information |
GO to Pinpoint Test D |
| U1000:00 |
Solid State Driver Protection Active -Driver Disabled: No Sub Type Information |
GO to Pinpoint Test A |
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
CHECK the vehicle service history for recent service actions related to this module. This DTC sets due to incomplete or incorrect PMI procedures. INSTALL As-Built data from Professional Technician Society (PTS) following diagnostic scan tool instructions under Module Programming>As-Built. |
| U3000:49 |
Control Module: Internal Electronic Failure |
ADDRESS all other Diagnostic Trouble Codes (DTCs) first. CLEAR the Diagnostic Trouble Codes (DTCs). REPEAT the self-test. If no BCM Diagnostic Trouble Codes (DTCs) are retrieved, INSTALL a new BCMB. REFER to: Body Control Module B (BCMB)
. |