RACM - Livery Only
DTC INDEX
| DTC | Description | Action |
|---|---|---|
| U0100:00 | Lost Communication With ECM/ PCM "A": No Sub Type Information | GO to Pinpoint Test AK |
| U0140:00 | Lost Communication With Body Control Module: No Sub Type Information | GO to Pinpoint Test AM |
| U0155:00 | Lost Communication With IPC Control Module: No Sub Type Information | GO to Pinpoint Test AP |
| U0184:00 | Lost Communication With Radio: No Sub Type Information | GO to Pinpoint Test AR |
| U0253:00 | Lost Communication With Accessory Protocol Interface Module: No Sub Type Information | GO to Pinpoint Test AX |
| U0422:00 | Invalid Data Received From Body Control Module: No Sub Type Information | RETRIEVE and FOLLOW Diagnostic Trouble Codes (DTCs) present in the BCM. Refer to: Body Control Module (BCM) .* If no Diagnostic Trouble Codes (DTCs) are present in the BCM, DIAGNOSE the observable symptom. |
| U1018:00 (Only if equipped with a CD player) | Lost Communication With Generic Function Module: No Sub Type Information | GO to Pinpoint Test AZ |
| U2013:63 | Switch Pack: Circuit / Component Protection Time-Out | GO to Pinpoint Test Y |
| U2100:00 | Initial Configuration Not Complete: No Sub Type Information | This DTC sets due to an incorrect or incomplete RACM configuration. Using a diagnostic scan tool, PERFORM the RACM programming procedure using as-built data. For information on as-built data. Refer to: Module Configuration - System Operation and Component Description . See: As-Built Data. |
| U2101:00 | Control Module Configuration Incompatible: No Sub Type Information | This DTC sets due to an incorrect or incomplete RACM configuration. Using a diagnostic scan tool, PERFORM the RACM programming procedure using as-built data. For information on as-built data. Refer to: Module Configuration - System Operation and Component Description . See: As-Built Data. |
| U3000:41 | Control Module: General Checksum Failure | CLEAR the DTC. WAIT at least 10 seconds. REPEAT the RACM self-test. If DTC U3000:41 is retrieved again, INSTALL a new RACM. |
| U3000:42 | Control Module: General Memory Failure | CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:42 is retrieved again, INSTALL a new RACM. |
| U3000:49 | Control Module: Internal Electronic Failure | ADDRESS all other RACM Diagnostic Trouble Codes (DTCs) first. After the cause of the concern is corrected, CLEAR all Continuous Memory Diagnostic Trouble Codes (CMDTCs). WAIT at least 10 seconds. RETRIEVE all Continuous Memory Diagnostic Trouble Codes (CMDTCs). If DTC U3000:49 is retrieved again, INSTALL a new RACM. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | GO to Pinpoint Test BA |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | GO to Pinpoint Test BB |