Disassembly And Assembly: Halfshaft: Disassembly
WARNING: This page is about a different variant/trim than selected.
- 1.
Remove the halfshaft from the vehicle. Refer to Halfshaft .
- 2.
Remove the 2 boot clamps.
 Courtesy of FORD MOTOR COMPANY
|
- 3.
Separate the boot from the inboard CV joint housing.
 Courtesy of FORD MOTOR COMPANY
|
- 4.
Remove the retaining ring.
 Courtesy of FORD MOTOR COMPANY
|
- 5.
Remove the inboard CV joint housing.
 Courtesy of FORD MOTOR COMPANY
|
- 6.
Index-mark the inner race and ball cage.
 Courtesy of FORD MOTOR COMPANY
|
 Courtesy of FORD MOTOR COMPANY
|
 Courtesy of FORD MOTOR COMPANY
|
- 9.
Remove the inner race and the ball cage.
 Courtesy of FORD MOTOR COMPANY
|
- 10.
Remove the inboard boot.
 Courtesy of FORD MOTOR COMPANY
|
- 11.
Remove the 2 boot clamps.
 Courtesy of FORD MOTOR COMPANY
|
- 12.
Remove the outboard boot.
 Courtesy of FORD MOTOR COMPANY
|
- 13.
NOTE:
If the grease is contaminated, clean and inspect the joint for wear. Install a new outboard CV joint and interconnecting shaft assembly if worn/damaged.
Check the CV joint grease for contamination.