In-Vehicle Repair: Flexplate: Installation

1.

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.

Install the flexplate and the bolts and tighten in sequence shown.
- Tighten to 80 Nm (59 lb-ft).

Fig 1: Flexplate Tightening Sequence

GFD135191

Courtesy of FORD MOTOR COMPANY

2.

Install the automatic transmission. Refer to: Automatic Transmission 6R80 .

3.

After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.