Module Network Input Messages - IPM-A
WARNING: This page is about a different car, the 2016 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.
| Broadcast Message | Originating Module | Message Purpose |
|---|---|---|
| Ambient air temperature | PCM | The ambient air temperature is used for heater operation. The IPM-A may command the camera windshield defrost heater on below 5°C (41°F). |
| Hands off status | PSCM | Data used to send a message to the IPC that a hands-off condition was detected after a lane keeping aid activation. |
| HUD module flash rate | HUD module | Suppresses LDW when there is a collision avoidance message. |
| Ignition key type | BCM | Prevents the system from being disabled when a MyKey® key is in use. |
| Ignition status | BCM | Enables the IPM-A. |
| Personalization mode intensity/sensitivity | IPC | Message contains the personalized set-up for the LDW. |
| Restraint impact event status | RCM | Suppresses LDW. |
| Transmission in reverse | PCM | Suppresses LDW. |
| Turn signal status | SCCM | Suppresses LDW on that side. |
| Vehicle lateral and longitudinal acceleration | RCM | Suppresses LDW. |
| Vehicle speed | PCM | The LDW system is active above 64 kmh (40 mph). |