Toe Adjustment - Front

WARNING: This page is about a different car, the 2016 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

1.

Using alignment equipment and the manufacturer's instructions, measure the front toe.

2.

Start the engine and center the steering wheel.

3.

Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.

4.

Remove the steering gear bellows clamps.

GFD90880

Courtesy of FORD MOTOR COMPANY

5.

Loosen the nuts.

GFD90881

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.

Rotate the tie rods as necessary to adjust the toe setting.

7.

Tighten the tie-rod jam nuts to 63 Nm (46 lb-ft).

GFD90881

Courtesy of FORD MOTOR COMPANY

8.

Recheck the toe settings and adjust as necessary.

9.

Install the steering gear bellows clamps.