Removal And Installation
- Drain the cooling system. For additional information, refer to Engine Cooling .
- Remove the 4 retainers and the underbody shield.
-
NOTE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.
Position a floor jack with a block of wood under the front of the oil pan.
- Remove the engine coolant degas bottle. For additional information, refer to Engine Cooling .
- Disconnect the upper radiator hose from the intake manifold.
- Remove the A/C tube bracket bolt from the upper RH shock tower.
- To install, tighten to 15 Nm (133 lb-in).
- Remove the A/C tube retaining clamp bolt from the lower RH shock tower.
- To install, tighten to 9 Nm (80 lb-in).
- Remove the 4 engine mount nuts.
- To install, tighten to 63 Nm (46 lb-ft).
- Remove the 3 bolts and the engine mount.
- To install, tighten to 90 Nm (66 lb-ft).
- To install, reverse the removal procedure.
- Fill and bleed the cooling system. For additional information, refer to Engine Cooling .