Removal And Installation

NOTE: For component identification and locations, refer to Seat - Exploded View, Front .

When installing a new Dual Climate Controlled Seat Module (DCSM), carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to Module Configuration .
Position the front passenger seat all the way back and up to access the DCSM.
Remove the DCSM in the following sequence.
- Remove the screws.
- Release the locking wedges on the 2 DCSM electrical connectors.
- Disconnect the electrical connectors.
- Remove the DCSM.
Courtesy of FORD MOTOR COMPANY
To install, reverse the removal procedure.
If a new DCSM has been installed, carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to Module Configuration .