Removal And Installation

WARNING: This page is about a different car, the 2016 Lincoln MKT. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For component identification and locations, refer to Seat - Exploded View, Front in this service information.

1.

When installing a new Dual Climate Controlled Seat Module (DCSM), carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to Module Configuration .

2.

Position the front passenger seat all the way back and up to access the DCSM.

3.

Remove the DCSM in the following sequence.
- Remove the screws.
- Release the locking wedges on the 2 DCSM electrical connectors.
- Disconnect the electrical connectors.
- Remove the DCSM.

GFD95561

Courtesy of FORD MOTOR COMPANY

4.

To install, reverse the removal procedure.

5.

If a new DCSM has been installed, carry out the appropriate steps in Programmable Module Installation (PMI). For additional information, refer to Module Configuration .