In-Vehicle Repair: Flexplate: Installation

NOTE: One of the 8 flexplate holes are offset so the flexplate can only be installed in one position.
• 1.
  Install the flexplate and the bolts and tighten in sequence shown.
  • Tighten to 80 Nm (59 lb-ft).

Fig 1: Flexplate Bolts Tightening Sequence

Courtesy of FORD MOTOR CO.

• 2.
  
  Install the automatic transmission. Refer to: Automatic Transaxle Transmission 6R80 .

• 3.
  
  After completing the repairs, use the scan tool to perform the Misfire Monitor Neutral Profile Correction procedure following the on-screen instructions.