LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2016 >> Navigator Select, RWD >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission - 6R80 >> In-Vehicle Repair >> Main Control >> Installation

Main Control: Installation

  1. 1.

    Inspect the bias spring to make sure it is positioned correctly in the transmission case.
GFD30920Courtesy of FORD MOTOR COMPANY

  1. 2.

    NOTE: Before installing the main control assembly into the transmission case, verify the presence and orientation of the thermal bypass valve, pump adapter seal and center support feed tube seals. Also note that one or more of the center support feed tube seals may have remained in the main control assembly during removal and should be installed into the transmission case at this time.

    Verify the 3 center support feed tube seals are in place.

    1. 1.

      Center support feed tube seal (7G199 Black)

    1. 2.

      Center support feed tube seal (7G087 Green or Orange)

    1. 3.

      Center support feed tube seal (7G084 Blue)
GFD30921Courtesy of FORD MOTOR COMPANY

  1. 3.

    Verify the rubber adapter is in place.
GFD30922Courtesy of FORD MOTOR COMPANY

  1. 4.

    Coat the thermal bypass valve with petroleum jelly to hold it in place and install the thermal bypass valve into the transmission case.
GFD30923Courtesy of FORD MOTOR COMPANY

  1. 5.

    Position the main control assembly in place and loosely install the 11 bolts.

    1. 1.

      Align the manual valve and control lever linkage.
GFD30924Courtesy of FORD MOTOR COMPANY

  1. 6.

    Tighten the main control bolts in the sequence shown in illustration.
    • Tighten to 8 Nm (71 lb-in).
Fig 1: Main Control Assembly Tightening Sequence
GFD30925Courtesy of FORD MOTOR COMPANY

  1. 7.

    If removed, install the bulkhead connector sleeve seals.
GFD30926Courtesy of FORD MOTOR COMPANY

  1. 8.

    With the release tab down and unlocked, push the outer shell of the bulkhead connector sleeve into the transmission. Make sure the bulkhead connector sleeve is fully seated into the molded leadframe.
GFD30927Courtesy of FORD MOTOR COMPANY

  1. 9.

    Press up on the tab and lock the outer shell of the bulkhead connector sleeve in place. Make sure that the locking tab is securely locked.
GFD30928Courtesy of FORD MOTOR COMPANY

  1. 10.

    Connect the transmission vehicle harness connector by pushing it in and twisting the outer shell to lock it in place.
GFD30915Courtesy of FORD MOTOR COMPANY

  1. 11.

    Install the transmission fluid pan and filter. Refer to Fluid Pan, Gasket and Filter .

  1. 12.

    NOTE: If an individual solenoid was replaced clear the adaptive strategy.

    Perform a Road Test - Adaptive Drive Cycle after the adaptive strategy is cleared. Refer to Shift Point Road Test .

  1. 13.

    NOTE: If the main control assembly was replaced, perform the Solenoid Body Strategy Data Download. Refer to Solenoid Body Strategy .

    Perform a Road Test - Adaptive Drive Cycle after the Solenoid Body Strategy Data Download. Refer to Shift Point Road Test .

scientia non olet · About LEMON Manuals