Toe Adjustment - Front

1.

Start the engine and center the steering wheel.

2.

Turn the engine OFF and, using a suitable steering wheel holding device, lock the steering wheel in the straight ahead position.

3.

Using alignment equipment and the manufacturer's instructions, measure the front toe.

4.

Remove the steering gear bellows clamps.

GFD96332

Courtesy of FORD MOTOR COMPANY

5.

Loosen the tie-rod jam nuts.

GFD96333

Courtesy of FORD MOTOR COMPANY

6.

NOTE: Do not allow the steering gear bellows to twist when the tie rod is rotated.

Rotate the tie rods until the toe setting is within specifications.

GFD96334

Courtesy of FORD MOTOR COMPANY

7.

Tighten the jam nuts to 90 Nm (66 lb-ft).

8.

Install the steering gear bellows clamps.