Removal And Installation
NOTE:
The air bag warning indicator illuminates when the correct Restraints Control Module(RCM) fuse is removed and the ignition is ON.
NOTE:
The Supplemental Restraint System(SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
All seats
- 2.
Depower the SRS. For additional information, refer to Supplemental Restraint System(SRS) Depowering and Repowering in the General Procedures portion of Supplemental Restraint System .
- 3.
Separate the safety belt retractor belt anchor from the seat in the following sequence.- 1.
Carefully pull up and out to remove the safety belt retractor belt anchor nut cover from the cushion side shield.
- 2.
Remove the safety belt anchor nut.- To install, tighten to 47 Nm (35 lb-ft).
- 3.
Separate the safety belt retractor belt anchor from the seat.
- 1.
- 4.
Remove the seat control switch in the following sequence.- 1.
Pull out and remove the seat control switch knob(s).
- 2.
If equipped with manual recline, release the clip and remove the manual recline handle.
- 3.
If equipped with manual lumbar, pull and remove the manual lumbar handle.
- 4.
Remove the cushion side shield screw(s).
- 5.
Slide the cushion side shield up in the rear to release the retainer.
- 6.
Slide the cushion side shield forward to disengage the retainer.
- 7.
Release the cushion side shield clips and separate the seat control switch.
- 8.
Disconnect the seat control switch electrical connector and remove the switch.
- 1.
- 6.
Repower the SRS.If a passenger seat has been serviced, do not prove out the SRS at this time. For additional information, refer to Supplemental Restraint System(SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
Passenger seat
- 7.
Carry out the Occupant Classification System(OCS) System Zero Seat Weight Test. For additional information, refer to the General Procedures portion of Supplemental Restraint System .