Common Specifications & Procedures
EDGE/MKX COMMON SPECIFICATIONS & PROCEDURES
| System | Specifications/Procedures | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 258 Ft. Lbs. (350 N.m) | ||
| Rear | 258 Ft. Lbs. (350 N.m) | ||
| Battery | SPECIFICATIONS | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Front Disc Brakes w/Torque | SPECIFICATIONS | ||
| Rear Disc Brakes w/Torque | SPECIFICATIONS | ||
| Charging | |||
| Generator w/Torque | SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | ACCESSORY DRIVE | ||
| Belt Routing | ACCESSORY DRIVE BELT ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | SPECIFICATIONS | ||
| Radiator Cap Pressure | 14-18 psi (95-124 kPa) | ||
| Thermostat R & I | |||
| 2.0L GDTI | THERMOSTAT HOUSING -- 2.0L GTDI | ||
| 3.5L & 3.7L | THERMOSTAT -- 3.5L, 3.7L | ||
| Water Pump R & I | |||
| 2.0L GDTI | COOLANT PUMP -- 2.0L GTDI | ||
| 3.5L & 3.7L | COOLANT PUMP -- 3.5L, 3.7L | ||
| Engine Mechanical | |||
| 2.0L GDTI | |||
| Compression | SPECIFICATIONS | ||
| Oil Pressure (Hot @ 2000 RPM) | 29.01-38.87 psi (200-268 kPa) | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 3.5L | |||
| Compression | SPECIFICATIONS | ||
| Oil Pressure (minimum at 1, 500 RPM with engine at normal operating temperature.) | 30 psi | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 3.7L | |||
| Compression | SPECIFICATIONS | ||
| Oil Pressure (minimum at 1, 500 RPM with engine at normal operating temperature.) | 30 psi | ||
| Overhaul | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate Torque | |||
| 2.0L GDTI | Refer to FLEXPLATE
for sequence. Stage 1: 50 Nm (37 lb-ft). Stage 2: 80 Nm (50 lb-ft). Stage 3: 112 Nm (83 lb-ft). |
||
| 3.5L & 3.7L | FLEXPLATE (3.5L) or FLEXPLATE (3.7L) | ||
| Fuel System | |||
| Fuel Filter Location | Located in fuel tank as part of Fuel Pump Module. | ||
| Fuel Filter R & I | FUEL PUMP MODULE | ||
| Pressure Release Procedure | FUEL SYSTEM PRESSURE RELEASE | ||
| Pressure Specification | GENERAL SPECIFICATIONS | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM PRESSURE TEST | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Routing) | Engines are equipped with Coil-on-plug ignition. | ||
| Spark Plugs | |||
| 2.0L GTDI | |||
| Type | CYFS12Y-2 | ||
| Gap | .031 In. (0.8 mm) | ||
| Torque | 106 In. Lbs. (12 N.m) | ||
| 3.5L & 3.7L | |||
| Type | Motorcraft CYFS12F-5 | ||
| Gap | .049-.053 In. (1.25-1.35 mm) | ||
| Torque | 133 In. Lbs. (15 N.m) | ||
| Starting | |||
| Starter | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lbs. (135 N.m) | ||